
Vỏ để bàn IKEA cho công tắc remote BILRESA nút đôi (Single/Double)
- Downloads
- 14
- Likes
- 4
- Views
- 135
- Remixes
- 0
- Comments
- 0
Files 4 12.9 MB
- Ikea_Bilresa_Tabletop_Stand_30_Double_1772316049.stlSTL · 4.2 MB
- Ikea_Bilresa_Tabletop_Stand_30_Single_1772316050.stlSTL · 2.2 MB
- Ikea_Bilresa_Tabletop_Stand_45_Single_1772316052.stlSTL · 2.2 MB
- Ikea_Bilresa_Tabletop_Stand_45_Double_1772316053.stlSTL · 4.3 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #231643
- Category
- Đồ Gia Dụng
- Published
Description
This is a simple, clean tabletop housing designed for the IKEA BILRESA smart dual button remote control (806.178.76). Since the BILRESA is a great affordable Matter-compatible button, I wanted a way to keep them organized on a desk or bedside table rather than just having them loose or stuck to a wall.
All models include a rear finger slot, allowing you to pick up the entire unit and hold it comfortably in your hand.
I have included two variations in 30 or 45 degree angles:
-
Single: Holds one BILRESA switch.
-
Double: Holds two BILRESA switches side-by-side.
The fit is designed to be snug enough to keep the switch in place during use, but allows for easy removal from the bottom if you need to access the pairing button or change the batteries. Add some non-slip pads to the bottom to stop it from sliding.
Print Instructions
-
Supports: None required.
-
Layer Height: 0.2mm works perfectly and looks great.
-
Infill: 15% is plenty, but you can go higher if you want more "heft" on the table.
-
Material: PLA, PETG, or ASA should all work fine.
Examples shown are printed with Eryone Galaxy PLA (30 degree models) and Overture Orange Matte PLA (45 degree model).
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 12.9 MB
- Largest file
- 4.3 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -
New -

-

-


