Skip to main content
F3D
Camera lùi cho drone: standoffs 32mm, xoay 120° 1

4 images

DIY

Camera lùi cho drone: standoffs 32mm, xoay 120°

By DrEnchanted_513663

Downloads
2
Views
69

Files 9 37.7 MB

  • 180D_Gear_PLA_or_TPU_1772144068.stlSTL · 651.6 KB
  • L.TPU_1772144068.stlSTL · 350.7 KB
  • Cam_House_1772144069.stlSTL · 26.9 MB
  • SlagPin_1772144071.stlSTL · 100.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I recommend printing the one file given or use supports. This model REQUIRES plastic coated wires for their stiffness. Silicone wires are to pliable and don't preform well.  Install servo, turn on servo and go to max and install the gear at it's max position. Then install camera housing at a max position. NOTE: there is 180degrees of movement but servos will only apply 120. There Max camera tilt can be adjusted slightly.  Wires must overlap in a circle within the servo lid as shown

Pull the wires into a tight circle to install lid. Assure they are not pinched and have full movement when camera is fully rotated in both directions.  NOTE: Servos vary and might require shimming and/or gear realignment.  Mounting holes are for standoffs 32mm to center. For cameras with upper wire plugs or lower wire plugs. As shown with the "Arris Cat" camera.

Read more Show less

Print spec

Formats
gcodestl
Model files
9
Total size
37.7 MB
Largest file
26.9 MB

0 comments

See all