Low Rider v1 tối đa 6 lines

I have not too much time for testing, so v2 came ahead me. I publish this anyway, somebody can find it usefull.

Ability to generate camshaft for 2-6 lines Low rider mmu. Line has 25mm, so add/remove length from rods as needed.

For 6 lines it is impossible to have release angle and it is very tight fit - i must fidle with cam angles in happy hare +-1 degree to not catch next gate wheel.

Do not forget to properly set selector servo in mmu_hardware.cfg, defaut values are for different servo and you will not get full 180 degree movement.

[mmu_servo selector_servo]
pin: mmu:MMU_SEL_SERVO
maximum_servo_angle: 180
minimum_pulse_width: 0.0005 #0.00070
maximum_pulse_width: 0.0025 #0.00230

ERB board holder included - you can use original board (see V2), but i have encoder, baley and EREC servo, so there not enough pins there ....

Original motor plate standoffs were too long by 2mm, and i used aliminium 80T puley instead of prined one i extended standoffs by 3mm (23mm) to use 3x30mm screws.

Currently i am testing EREC cutter with encoder, so keep finger crosed :-).