Skip to main content
F3D
Giá Treo Giấy Vệ Sinh Tham Số (Somewhat) Parametric 1

1 image

Đồ Gia Dụng

Giá Treo Giấy Vệ Sinh Tham Số (Somewhat) Parametric

By RickSeiden_27923

Views
65

Files 4 269.4 KB

  • Toilet_Paper_Roll_Holder_Big_End_1771906899.3mf3MF · 25.3 KB
  • Toilet_Paper_Roll_Holder_Little_End_1771906900.3mf3MF · 25.1 KB
  • Toilet_Paper_Roll_Holder_Peg_1771906901.3mf3MF · 13 KB
  • Toilet_Paper_Roll_Holder_1771906902.f3dF3D · 206.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#225411
Category
Đồ Gia Dụng
Published

Description

Toilet paper rolls are bigger than they used to be and standard holders can't handle them.  You either can't load the roll onto the holder at all, or the roll rubs against the bag of the holder.

This design fixes this by extending the center of the roll holder out a bit.

To print it, I suggest 0.2 mm layer height with 100% infill. Stand the tubes on their ends with the "feet" touching the bed.  Then print two pegs with their larger bottom on the bed.

Use some super glue or epoxy to glue the pegs into the tubes and you're set to go.  Take your existing holder out and pull it apart to get at the spring. Slide the spring into the bigger tube and slide the smaller tube into the bigger one until you get past the lips on the ends of the tubes.

Now you can use it like a normal holder, but have that little bit of extra room for your larger roll.

(This was inspired by the old Charmin roll give-away from 10 or so years ago.  Ours was not really holding up well, so I designed this to replace it.)

I've included the Fusion design files so you can adjust the size to fix your needs. I don't promise it will adjust well if you change the parameters, and if it doesn't, there's not much I'll be able to do to help out with it.  I'm offering the design file as-is.

Read more Show less

Print spec

Formats
3mff3d
Model files
4
Total size
269.4 KB
Largest file
206.1 KB

0 comments

See all