Biamp Tesira Phoenix Connector Strain Releif

I bought a used Biamp Tesira DSP and the strain relief had snapped off some of the included phoenix connectors. This design is simpler and lacks some of the features of the original. It may not hold a cable tie super well, but I used heatshrink and that works fine.

Installation: The original strain relief looks like it is part of the body of the connector but it's actually adheared underneath. It can be gently pried and peeled off with a thin scraper, leaving a clean flat surface for the replacement. I put a small blob of CA/superglue on the base of the new strain relief and stuck the connector on top.

There is a tiny bit that sticks up covering the middle terminal. That was left over from a previous design iteration and isn't needed. Just snip it off. I forgot about it until literally just now. One day I'll upload a v2 with it removed.

Print settings

Printer: Bambu P1S, 0.4mm nozzle

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: Doesn't matter, it's like 1 layer

 Filament: Tecor PETG, Black