Xshot MPP Collet Frontend

This mod requires the blaster to be opened, and replaces the stock collet that comes on the blaster. It does re-use the breach from the stock blaster - which is pressed into the “Replacement Internal Mate” as seen below. 

The collet can go inside the shroud connected to the “Replacement Internal Mate”, or on the outside of the shroud connected to the shroud. You will need to print one of each of the "Short" and "Long" pins. the short pin will be used in the topmost hole, and the long pin in the lowermost hole. See below for examples of the shrouds that have the collet inside vs external

.                                     

                       Internal Collet                                                                                       External Collet

No supports are needed with the “Replacement Internal Mate”, nor are there any supports required with the “Flat” frontends.

I have published the STEP file for the mating geometry for the shroud. Please contact me before selling shrouds, as TBH, it does depend on who it is and what it is- but feel free to publish them. I am looking for as many variants as I can get out in the world. 

All variants of this require a collet (either showing or inside the shroud). you can find it here