Skip to main content
F3D
Vỏ Raspberry CM5 IO Case (không chính thức) cho CM5 IO Board 1

6 images

DIY

Vỏ Raspberry CM5 IO Case (không chính thức) cho CM5 IO Board

By Rafael_58368

Downloads
3
Likes
1
Views
134

Files 8 2.1 MB

  • Enclosure-Bottom-V1-CM5-IO-IN_1771396364.3mf3MF · 310.4 KB
  • Enclosure-Top-V1-CM5-IO-IN_1771396365.3mf3MF · 216.2 KB
  • Enclosure-Bottom-V1-CM5-IO-ST_1771396366.3mf3MF · 310.6 KB
  • Enclosure-Top-V1-CM5-IO-ST_1771396367.3mf3MF · 216.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A modern enclosure for this fantastic Raspberry device with the following features:

  • Very tight geometry. 

  • Air ventilation placed where heat is mostly generated.

  • Textured enclosure for less 3d printish/more modern look.

  • Fasteners: Insert Version (IN) / Self Tapping (ST) version.

  • Version with Wireless Antenna hole (WL)

  • Only 2 external screws + groove/lip for fastening

  • Optional multimaterial for Logos and Info, delete them to print recess instead 

  • Placement recess for rubber feet

Printing Instructions

Your printer needs to have good dimensional accuracy and handle 0.2mm tolerances.

  • Layer size 0.2mm

  • Print with Front and Back plates on platform (see example)

  • No supports 

  • No brim required, but clean bed properly, adhesion can be challenging.

Assembly Instructions

  • Install M2.5 Inserts (IN version) / See photos

  • Install M2.5 machined screws (IN version) or 2.5mm self tapping screws (ST version) to attach the PCB

  • Top case must first insert horizontal grove, and then slide forward.

Note: I have not printed ST variants and monomaterial. Feedback appreciated.

This case is NOT an Official Raspberry Pi Accessory.

Read more Show less

Print spec

Formats
3mf
Model files
8
Total size
2.1 MB
Largest file
310.6 KB

0 comments

See all