Chân đế mặt đáy cho Lenovo ThinkCentre M725s SFF (small form factor)

Not a great design but good enough. It is meant for the bottom side of the case. (The bigger side that has feet) Dimensions are slightly off but it fits. Original foot clips in but I didn't think that would work with the limitations of 3D printing. It will rest nicely in the existing holes and some hot glue from the inside should hold it in place. It is probably compatible with other models of Lenovo but I only tested it on the M725s.

I had no issues printing it as designed on my Ender 3 S1. If your printer has issues with the overhangs might want to flip it upside down though.