Skip to main content
F3D
Pát (Bracket) gắn heater gốm nhỏ vào tent enclosure 1

4 images

Máy In 3D

Pát (Bracket) gắn heater gốm nhỏ vào tent enclosure

By ShawnN_2071431

Views
58

Files 1 95.8 KB

  • Heater_mount_brkt_1771218891.stlSTL · 95.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#221877
Category
Máy In 3D
Published
License
OCL

Description

I needed a heated enclosure so this is my solution. My early version that I'm using was printed in PETG and one of the hooks broke when I was installing it so I thickened the hooks and added add'l supports. The bosses fit into the screw "wells" of the heater and attach utilizing the original screws. A piece of tape holds the tip-over switch closed (white round item on the heater bottom).

I'm taking this idea a step further by splicing an on/off switch inline in the cord so I can control it without opening the tent. Purchased on Amazon.

It prints "upside down" with supports only required under the bosses. My 1st make the bosses were ever so slightly too close together so I printed at 100.5% scale and it fit perfectly. PLA will not survive, trust me!

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
95.8 KB
Largest file
95.8 KB

0 comments

See all