Case Honeycomb Cứng Cáp Hơn cho LattePanda 3 Delta

I really like the honeycomb motif on this LattePanda 3 Delta case. Alas, my success rate at producing an intact case has been somewhere around 20-30%. The model prints fine, but it's nearly impossible to remove the support plates without breaking the model. I also find the 1-mm walls rather flimsy. I longed for a sturdier model.

I re-modelled this from scratch in FreeCAD based on the dimensions of the original model. I made the walls 2 mm thick and added reinforcements for additional strength. I also added a simple yet accessible power button. I removed the support plates from the ports. The model prints fine on my MK3.5 without support.

Secure the LattePanda 3 Delta board to the body with the original screws supplied with the board. Secure the lid to the body with four M3x16 screws.

Printed in PETG, 0.2 mm layer height, 20% gyroid infill.