
Khay Lưu Trữ Điện Trở Tiết Kiệm
- Downloads
- 584
- Likes
- 123
- Views
- 2,532
- Remixes
- 2
- Comments
- 0
Files 7 3.6 MB
- resistor_storage_tubes_1770872868.scadSCAD · 5.5 KB
- lid_1770872869.stlSTL · 34.3 KB
- tube_1770872870.stlSTL · 34.7 KB
- rack_8x8_1770872870.stlSTL · 1.1 MB
Make a variant with AI
Build another version of this model.
Remix versions 2
Kệ đựng điện trở tiết kiệm tương thích GridfinityByNicroxio_1211124 · 03/21/2026
Hộp Lưu Trữ Điện Trở Tiết KiệmBymadethis_4088841 · 02/12/2026
Details
- Model ID
- #218891
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
I spent a long time trying to find a good way for stroring resistors but couldn't find anything that was both easily accessible and small enough to fit into my drawers upright.
Each tube is 64 mm tall, so it fits in e.g. an IKEA Alex drawer and uses only about 3g of filament incl. the lid.
The lids are held in place by little notches, so they won't come off accidentally and spill your resistors everywhere.
Rack Size
A few different sizes for the rack are provided as stls but any arrangement can be generated via the OpenSCAD file. Do note that the preview doesn't seem to work for the rack, but rendering will.
Printing Instructions
For the tubes and lids, it is crucial to print them with a line width of 0.6mm (fine for both 0.4 and 0.5mm nozzles) so that walls are exactly one perimeter thick.
Print spec
- Formats
- scadstl
- Model files
- 7
- Total size
- 3.6 MB
- Largest file
- 1.7 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-
New -

-

-


