Đế để bàn cho Drok DC Volt Ammeter Panel (desktop base)

Desktop enclosure for the Drok DC 4.5-100V Digital Voltmeter Ammeter Multimeter panel and 50A shunt.

There are pegs built into the base to hold the shunt in place without needing screws. There are vent holes in the front to allow some airflow and large holes in the back to allow the wires to exit. You will need (4) M3 heatset inserts and (4) m3x8-12mm screws. This prints easily on a single plate with no supports, just place the face of the top plate down.

Printed in PETG, Orca modifiers used for 100% infill where the inserts will be drilled. I just used superglue to set them in the corners. After printing you can drill these out with 4mm, 9/64, or 1/8 drill bit. They will all work.

v2 bottom updated to include front insert location as part of the base, so you only need to print and glue the 2 top corners.