Mac Mini M4 gắn Rack 10 Inch (Phiên bản mới!)

This is a bracket to put a M4 Mac mini in a 10 inch network rack. I takes up 1.3Us of space it works quite well on the Geekpi/Deskpi T1 rack in the bottom U as there is some extra space underneath to not waste any Us

I have now also revised this to make some extra versions! there is now 6 versions!

First there is the OG design already loved and downloaded by many in the community (Thank you all by the way) 

Next there is the lightweight model that shaves it down from 95g of filament to 78g

Then there is the Superleggera which goes even further to only 62g of filament! 

Then to round it out I have also created a version of each that fills the 2nd U completly and adds a vent so if your rack is stacked with lots of heat generating components this both gives the Mac Mini a place to pull fresh air in it also spaces it away from anything else in the rack. 

Finally for anyone that has already printed one of these mounts i have also uploaded the vent plate on its own to so you dont need to reprint the whole thing if you want to fill in the gap. 

(All filament weights as sliced in bambu studio)