Bambu P1P Poop Chute - Magnet Remix

Uses 6x6mm magnets to attach the chute to the back of the P1P.  This model is a tighter fit for my P1P with square printed side panels.

Print Settings

• 0.4mm nozzle
• 0.2mm layer height
• Top surface only ironing
• 4 Wall Loops
• 30% Sparse Infil Density
• No Brim (won't fit on build plate with brim)
• No support

The magnets are a tight fit when pushing in.  I gently tapped them with a hammer and they went right in.

Design uses 575g of filament and took 9h25m to print.  Its a big sturdy and durable poop chute but will catch everything.  The side panels in my printer stick out just a tad and is not completely flush with the back panel so I am using 6x6mm magnets instead of the 6x3mm magnets in the original design.