
Trái Tim Lật Phập Phồng – Bất Ngờ Ngày Valentine
- Downloads
- 147
- Likes
- 70
- Views
- 1,159
- Remixes
- 1
- Comments
- 0
Files 2 157.9 KB
- Fluttering_Hearts_v1.0_1770593205.3mf3MF · 63.8 KB
- Fluttering_Hearts_v1.0_1770593205.f3dF3D · 94.2 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #213110
- Category
- Sự Kiện - Lễ Hội
- Published
- License
- OCL
Description
Inspired by fluttering dragonfly birthday cards, these hearts are a fun way to add a little extra surprise to your valentine's day card. Word of caution, if your partner startles easily give them a little warning. I don't want to be the cause of any break ups!
Assembly required, you will need:
- Your favourite glue for bonding 3D prints (I used CA glue). I found a toothpick was a great applicator.
- Small rubber bands (2 small hair elastics from the dollar store work great!)
For printing, I used a Prusa Mini+ (Input Shaper profile) on the 0.10mm Fast Detail print setting with a single perimeter, and no supports.
Assembly:
You will have 4 printed parts & 2 small elastics
Glue the 2 upper halves and 2 lower halves together *Note* It's easiest to glue them individually, just don't glue the neck of the lower half yet (see next step)
Since the neck of the lower half hasn't been glued together, you can split it and insert the upper half. After inserting the top, put a small dot of glue on each site of the neck (careful not to get any glue where the top rotates). This is where a toothpick comes in handy as an applicator
Make sure the top spins freely once the glue dries. If it does, you're ready to move onto the rubber bands
First, thread both rubber bands through the bottom hole on the lower half. Next bring one set of ends around the back and through the center cut out. Finally pass the ends from the bottom hole, through the ends in the center cut out.
Stretch the bands onto the top hook
Now wind it up and let it go!
Print spec
- Formats
- 3mff3d
- Model files
- 2
- Total size
- 157.9 KB
- Largest file
- 94.2 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -

-
New -
New -

-

-



