
Dụng Cụ Tiện Ích
Stax Lambda X ModMic - Ngàm gắn ModMic không cần nam châm
- Downloads
- 0
- Likes
- 1
- Views
- 91
- Remixes
- 0
- Comments
- 0
Files 4 973.2 KB
- Stax_mod_Mic_Bolt_1770337580.stlSTL · 668.6 KB
- Stax_ModMic_1770337581.stlSTL · 144.6 KB
- Stax_ModMic_TPU_1770337582.stlSTL · 145.4 KB
- Stax_ModMic_CableHolder_1770337583.stlSTL · 14.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #212087
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Attachment for my old ModMic on my Stax Lambda.
It works with almost any aftermarket ModMic clone.
I did not want to have a magnet next to the Stax drivers, as they are sensitive enough. I suspect this may have caused long term damage to my Koss electrostat.....
Pre installed Support:
They needs to be snapped off after printing. More information is shown in picture 4. Snap point are marked in RED.
Print Settings:
-
Infill: 100% (works well, no need to go higher)
-
Material: PLA
-
Nozzle 0.4mm
-
Layer high 0.12mm
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 973.2 KB
- Largest file
- 668.6 KB
0 comments
You may also like 12 models
See all-
New -

-

-
New -

-
New -

-
New -
New -
New -

-


