
Case LILYGO T-Display S3 Touch ESP32
- Downloads
- 0
- Likes
- 2
- Views
- 110
- Remixes
- 0
- Comments
- 0
Files 2 280.6 KB
- LILYGO_T-Display_S3_Touch_-_Case_Generic_1770092451.3mf3MF · 234.3 KB
- LILYGO_T-Display_S3_Touch_-_Case_Back_Generic_1770092452.3mf3MF · 46.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #210200
- Category
- DIY
- Published
Description
Modified my LILYGO T-Display S3 case to be used for General use.
back case allows for installation of 102535 Lipo Battery and can accept upto 102545.
Switch is for a Slider Switch SS-12F15 with 4mm switch height - can be found anywhere.
prints in 2 pieces so nice and easy.
to mount the switch use a soldering iron set to ~120 degrees with a flat tip and squash the pins down to act as a rivet of sorts, didn't want screws to be a requirement. I'm sure you could just as easily use a lighter or hob to heat up some metal to achieve the same thing in the absence of a soldering iron
Print spec
- Formats
- 3mf
- Model files
- 2
- Total size
- 280.6 KB
- Largest file
- 234.3 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-
New -

-

-

-
New

