Skip to main content
F3D
MagFace - Trạm sạc MagSafe cho iPhone và Apple Watch 1

3 images

DIY

MagFace - Trạm sạc MagSafe cho iPhone và Apple Watch

By Greenhat_30308

Downloads
2,159
Likes
322
Views
10,426
Remixes
1

Files 3 22.4 MB

  • MagFace_v1_Supports_Slicer_1770088304.3mf3MF · 1.4 MB
  • MagFace_v1_1770088305.stlSTL · 5.1 MB
  • MagFace_v1_Supports_1770088306.gcodeGCODE · 15.9 MB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

I wanted a fun and better way to use the MagSafe chargers for my iPhone and Apple Watch, so I designed this! :) 

Printed on MK3S with painted on supports for hands and top of circle face.   3mf attached is the slicer file with settings and painted supports.    I'm not sure the supports for the top of the circles are necessary, but I added them just in case.   Have not tried without.

The dog is pretty small, so the connector goes in pretty tight, I needed to use a screwdriver to gently push it all the way through.   There are channels on the bottom to route the wires. It's pretty tight, so you may use something to push the wires into the channels.  

I used a sheet of NanoSuction tape to hold it down on my nightstand.  Works amazingly well!  This is the one I purchased from Amazon, but you can search for NanoSuction or MicroSuction.  https://a.co/d/du2f51W

I hope you enjoy it!

Read more Show less

Print spec

Formats
3mfgcodestl
Model files
3
Total size
22.4 MB
Largest file
15.9 MB

0 comments

See all