Skip to main content
F3D
FT Panel Clips (cho 2020 extrusions) – Kẹp panel không cần… 1

3 images

Máy In 3D

FT Panel Clips (cho 2020 extrusions) – Kẹp panel không cần ốc cho Voron

By FizzysTech

Downloads
771
Likes
195
Views
5,189
Remixes
1

Files 13 3.4 MB

  • FT_Key_Tool_1770078972.stlSTL · 5.4 KB
  • FT_Corner_Panel_Bracket_S1_1770078972.stlSTL · 424.2 KB
  • FT_Panel_Bracket_S1_1770078973.stlSTL · 237.8 KB
  • FT_Key_Low_Profile_S1_1770078974.stlSTL · 185.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

FT PANEL CLIPS (for 2020 extrusions)

FT Panel Clips work with Voron 2.4 / Trident or any other squared frame printer using 2020 extrusions. They have been designed to remove the need for any hardware (hammer head t-nuts and screws). 

INTRODUCTION

These panel clips were designed to make servicing the printer easier with the quick release design. All parts to mount the panels are printed and serve as a direct replacement for the original panel mounts.

INSTALLATION INSTRUCTIONS

The Voron 2.4 and Trident uses 3mm thick clear panels (with 3mm foam tape) and 4mm thick black rear panel (with 1mm foam tape). 

  1. Rear panel
    1. Install 1mm foam tape around the edges of the panels where they meet the extrusions
    2. mount the 4mm rear panel using the parts labeled S1/Set 1
    3. Should you prefer to use the Low Profile Keys then use the Key Tool to install them as this provides a good grip to push down and turn the keys
  2. Side and top panel
    1. Install 3mm foam tape around the edges of the panels where they meet the extrusions
    2. mount the 3mm panels using the parts labeled S2/Set 2
    3. Should you prefer to use the Low Profile Keys then use the Key Tool to install them as this provides a good grip to push down and turn the keys

LDO specs for the Top and rear panel are to use 3mm panels with 1mm foam tape. For this a 3rd set has been created.

  1. Rear and Top LDO panels
    1. Install 1mm foam tape around the edges of the panels where they meet the extrusions
    2. mount the 3mm panels using the parts labeled S3/Set 3
    3. Should you prefer to use the Low Profile Keys then use the Key Tool to install them as this provides a good grip to push down and turn the keys

Should you have any queries reach out to us on Discord

I hope you acknowledge the time and effort involved in fine-tuning this modification. If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :) 

Do let me know if there are any other combination thickness panels and foam tape that you want to use and additional STL's can be provided.

CHANGE LOG

23-Oct-24

  1. Added low profile keys as requested by the community.
  2. Added a key tool to help grip the low profile keys making them easy to turn.

27-Jun-24

  1. Added S3/Set 3 that addresses LDO specs of 3mm panel with 1mm foam tape.

Read more Show less

Print spec

Formats
stl
Model files
13
Total size
3.4 MB
Largest file
491.7 KB

0 comments

See all