Dobsonian Azimuth Slider

Useful for an azimuth bearing/slider using minimal PTFE tube.

The flat head screws compress the PFTE tube to lock it in place. The PTFE fit is pretty tight as is, I found one corner to be very tight, likely due to a z-seam. Print one to test - slight scaling could be necessary depending on  your printer and PTFE tube.

PTFE Tube outer diameter should be 4.0mm

FHCS Screws

• #8 x 1 in. #2 Phillips Drive, Flat Head 

-- Or Similar --

• Head Diameter <= ~9mm

• Male Thread Max Diameter:  ~5mm

• Length <= your substrate that you mount to; >= 10mm