Riser chỉ dành cho Creality K2 Pro dùng kính

I looked up the design from the Bambu community. But since Riser did not find a similar design for the K2 PRO, he made the model himself. There is only support in two places where the dovetail connection is used. (Unfortunately, I did not find a solution to make the first cut at 90 degrees). I used a tolerance of 0.3 in the dovetail joint, as I planned to install it on glue. Additionally, I pasted thick paper at the points of contact with the glass, since glass does not like irregularities. I used the "Gyroid" filling by 15%. This is enough for durability and printing speed.

Tip: for high-quality surface printing, print as far away from the side fan as possible, so there will be no damage from the air jet. I also attached the layout file.

PS And yes, the cooling is good, until the temperature rise is detected with the door closed.

PSS I have a better version: