
MGT tương thích người chơi đọc đèn
- Downloads
- 15
- Likes
- 37
- Views
- 362
- Remixes
- 0
- Comments
- 0
Files 8 6.8 MB
- Light_Holder_Blank_1765551449.stlSTL · 103.6 KB
- Light_Holder_D20_1765551450.stlSTL · 161.8 KB
- Light_Holder_DnD_Ampersand_1765551451.stlSTL · 725 KB
- Light_Holder_Cthulhu_1765551453.stlSTL · 695.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #20792
- Category
- DIY
- Published
Description
Like many GM's these days, I frequently make use of smart lights to set some ambiance during my sessions. However recently during a session it was pointed out that, on occasion, this can lead to a situation where the players can't clearly read their character sheets. Being a thoroughly sensible and pragmatic individual, I took this feedback and immediately set about building a personal lighting system for the extremely over-engineered modular gaming table due to arrive at my home in a month or so.
This accessory is designed to connect either to the top rail of a player desk or the inner rail of the table itself and provide a personal dimmable LED light for players to read even if the room is somewhat dark. it does require some additional hardware - two of these countersunk screw-in magnets, two #6 woodscrews roughly 20mm (¾") long, and this rechargeable booklight I found on Amazon. Main advantage of this design is that the clip meant to hold it to a book's cover slides off, giving you a nice low-profile puck that can slide into this bracket and yield a much more sleek look. And it doesn't hurt that they're also quite cheap, either.
All the STLs are provided in what I consider the optimal orientation for printing, which should keep all the visible surfaces looking clean and let you forgo supports. I personally printed it in some cheap Wood PLA from Praline (rosewood, specifically) and would definitely recommend using a similar material if you have one you like. I did my best to make sure that the reading light would sit tight in the socket but still be easy to pull out and I think the prints mostly succeed - but I did have one that went and seized up on me requiring the creative use of heat and a butter knife to get the two separated without damaging anything. So definitely move slowly when testing for a fit - and maybe consider sanding down the body of the light a little in the corners to give yourself some more space if things feel too tight. I can say from experience it's a lot easier than trying to get purchase in the slot with a needle file.
Print spec
- Formats
- stepstl
- Model files
- 8
- Total size
- 6.8 MB
- Largest file
- 3.8 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-
New -
New -

-


