
CH1-C DIY Tai nghe Closed back (Closed-back headphones)
- Downloads
- 2
- Likes
- 1
- Views
- 113
- Remixes
- 0
- Comments
- 0
Files 8 1.9 MB
- AT_Pad_Plate_1769817366.stepSTEP · 80.8 KB
- Gasket_Print_TPU_1769817367.stepSTEP · 11.4 KB
- Body_Mirror_X_Axis_1769817368.stepSTEP · 131.9 KB
- Rear_Cup_print_0_bottom_layers_5_gyroid_infill_1769817368.stepSTEP · 20.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #206696
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Headphone design based around the Peerless Tymphony 50mm driver.
The goal of this project was to build on what I have learnt from working on my CH1 open back design and experiment with closed back cup designs.
I wanted to test out an idea I had of using 3d printed infill patterns to control resonance within the cup, rather than relying on other materials. The goal was to make them cheaper and simpler to construct.
I have tried to document what I have learnt here https://www.head-fi.org/threads/diy-3d-printed-headphone-journey.979090/
The size of the cups was intentionally scaled so that they would fit the wonderful Capra Audio headband and Satyr3 yokes. This means that they will also fit a range of third-party headbands found on Amazon and AliExpress.
BOM:
Drivers - Peerless 50mm
Pads - Aliexpress Fenestrated "punching" AT style pads
Cable Connectors - PJ392 3.5mm
Screws - FHCS + Pan head M3 8 and 10mm
Threaded Inserts - M3 Heat Set
Washers - M3
Tuning Material - 1.5mm(1-2mm) 30% wool blend felt
Instructions:
- Make sure to print the gasket part in TPU
- For the rear cup, set the supports to manual and add them only to the centre. Print it with 0 bottom layers, a 5% gyroid infill and add enough walls to bind the posts to the infill and cup wall based on your nozzle size.
- Cut the 1.5mm felt into a 50mm diameter ring to sit behind the driver and seal the gaps as shown in the photograph
- If you use the Capra Audio headband, then depending on the length of screws that you use, you may need to place some m3 washers between the yokes and the cups to increase the clearance slightly.
The Measurements provided are from a custom rig and so aren't comparable to anything else other than the measurements given, as such, I've provided measurements from other headphones to be used as a known reference.
Print spec
- Formats
- stepstl
- Model files
- 8
- Total size
- 1.9 MB
- Largest file
- 669.2 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-
New -
New -

-

-

-

-

-


