Core One+ Vent Test

Tesing the vent operation is difficult because the firmware remembers where it thinks the vent is and so it doesn't change the vent position unless you load a filament like ASA or ABS. And then it takes ages for the printer do all its print startup stuff before it adjusts the vent.

There's a great post here to fix that - so it always adjusts the print for each job.

https://forum.prusa3d.com/forum/prusa-core-one-general-discussion-announcements-and-releases/fixing-the-automatic-chamber-vent/

But if you have just installed the vent upgrade and want to see if its working this gcode

• Closes the Vent

• Opens the Vent

• Closes the Vent

• Opens the Vent

So just print this to test the vent open close

Note the vent stuff is in  a zip file because printables won't upload a raw gcode with the M870 command. Ignore the gcode file it won't do anything with the vent