Xích dẫn cáp đa năng semi-open (Semi open universal cable drag chain)

2020/04/01: Added Fusion 360 source file.

There's plenty of various cable drag chains out there on Thingiverse but I haven't found any that allows installation without disassembly of wires.

Apart from that the chains I've seen were quite bulky.

That's why I designed my own version i Fusion 360, allowing me to customize all the features of chain link:

• height (12 mm)
• length - distance between link hinges (20 mm)
• width - outer distance between walls (20 mm)
• diameter - outer diameter of flexion (80 mm).

I can also change clearances/tolerances and a few more attributes.

Let me know if you need other dimensions or higher/over clearances.

Thanks to tolerances (here 0.25 mm) the chain links can be printed assembled or separately. It's important to print slow, not more than 15-20 mm/s.

After printing the links might be fused a bit. Use a little force to crack them loose. For each link you can also grab and squeeze join with two fingers and swing the adjacent link a couple times. That will clean the joint from any residues.

If you're not sure about capabilities of your printer/filament then you can check it with my economic fidget spinner tolerance test: https://www.thingiverse.com/thing:2949885

Here you can see the chain in action dragging Y axis cables in my Tevo Tarantula: https://www.youtube.com/watch?v=HF8_3mJsSMU

Check out my other designs: https://www.thingiverse.com/DaVinci2000/designs

Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

25%

Notes:

For best results print slow, 15-20 mm/s.

PLA should be fine in most cases.

Print lid/s flat (up side down)

Category: 3D Printer Parts