Giá đỡ điện thoại CAT 33

This phone holder will hold a CAT 33. It was designed to work with a CAT 33 and will not work with another phone as is.

The width, height and thickness of the phone are crucial to work with this holder, as is.

I designed it in fusion but will not publish a step file as my workflow is an absolute mess.

You can adapt this holder to your specific phones in a few minutes using Tinkercad.

Print everything, grab the LARGE PART and the SMALL PART, assemble them, sanding them if needed for the hinge to be smooth. I used a section of 2mm thick steel bar as a pin for the hinge.

DO NOT USE A PIECE OF FILAMENT as a pin, it will break.

The holes of the large part are not drilled, because I prefer printing them shut like that and piercing them later with a soldering iron, to melt the plastic and reinforce each hole.

I assume that the rest of the assembly is obvious.

I like to have the rubber band engaged in the LARGE PART only when using the holder.