Giá gắn Qidi Plus4 Box Spoolholder Mount

This is a remix to allow the Qidi Plus4 box hub bracket to attach at the same time as the spool holder. As you can see from the images, it does not block access to the screws for removing the back panel.

This spool holder can use either metric or imperial hardware, depending on what is easier for you to obtain. See the following remix for the list of imperial hardware required and some additional instructions.

Print it in the orientation it imports and no supports are needed. I used PETG at 4 perimeters.

When installing, be sure to not overtighten the screws that thread into the back panel of the printer

If you need a longer arm than the one in the original design due to the size of your riser and desire to hold the spool in a higher position, please see the following remix