Tay spool holder dài hơn cho Qidi Plus4

This spoolholder arm is lengthened so that it has sufficient clearance from risers up to 50mm tall.
I also modified its hole pattern so that it can be set to a 10 o'clock position, as seen in the photos. This would allow it to not interfere with a Qidi Box sitting atop the printer. You would need a PTFE y-splitter to be able to select between the box and external spool.

This arm works for both metric and imperial hardware. I recommend using a nylock nut or blue loctite for the nut that holds the spool-holder, especially when the spool is held above the PTFE input, since it will continuously be trying to loosen the screw.

Printed with PETG at 4 perimeters and 25% hexagonal infill in the orientation which it imports. You will need to use supports for the one hexagonal opening.

Please see the following remix for details about the rest of the parts you will need.

Finally, this second remix supports holding the box hub at the same time