
Kẹp chống nắp capo Classic Mini (thay thế CZH209)
- Downloads
- 6
- Likes
- 5
- Views
- 71
- Remixes
- 0
- Comments
- 0
Files 3 637.7 KB
- Classic_Mini_Bonnet_Stay_Clip_v10_1768918934.f3dF3D · 158.6 KB
- Classic_Mini_Bonnet_Stay_Clip_v10_1768918935.stepSTEP · 128.2 KB
- Classic_Mini_Bonnet_Stay_Clip_v10_1768918936.stlSTL · 351 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #201218
- Category
- DIY
- Published
Description
A little plastic clip to replace the original metal bonnet stay clip on a Mini (Part Nr. CZH209) if it breaks like mine did.
To install, insert the bottom bit in the slit in the bonnet and then rotate the part 90° to the right to lock it in place.
Be careful not to use too much force rotating the clip or it will break.
If turning is not possible, check to see if the sheet metal around the slot is even.
Tested on a Mini SPI with a bonnet rod diameter of about 6,25mm.
Print with the flat side down (as uploaded), so that the layers go alongside the clip.
Print with 4 walls and support at 0.2mm or 0.16mm layers in PETG or similar heat-resistant material.
Fusion and step file attached, feel free to remix!
Print spec
- Formats
- f3dstepstl
- Model files
- 3
- Total size
- 637.7 KB
- Largest file
- 351 KB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-

-
New -
New -


