Càng Yoke Earcup cho Audio-Technica ATH-M40x

I made this because my original yoke broke in the hinge area. This model does not include the hinge mechanism.
The model consists of 2 pieces: the main yoke and a clamp for the hinge.
The model is of the Left side. Just mirror the yoke piece if you need the Right side.
This yoke allows full earcup articulation of the original.

For the assembly:

To avoid soldering, the original yoke has to be broken in couple of places to release the cable. This 3D printed model does not require soldering to reassemble.
Assembly requires 3 factory screws from the original headphone yoke assembly

For 3D printing:

Requires snug supports below the Earcup hinge pins.
Ideally use PETG, maybe ABS. PLA might be too stiff, because some flexibility is required to attach the earcup to the yoke.

Printing settings I used:
Nozzle: 0,4mm
Layers: 0,12mm
Walls: 4
Top/Bottom layers: 8
Infill: Cubic at 15%