
Power rack Hook Powerrack Haken – Móc treo gọn cho power rack
- Downloads
- 0
- Likes
- 0
- Views
- 70
- Remixes
- 0
- Comments
- 0
Files 4 4.4 MB
- RackHook51x51x10.5_1767996685.stlSTL · 1.6 MB
- RackHook41x41x14_1767996686.stlSTL · 2.4 MB
- RackHookSTEP_1767996687.stpSTP · 32 KB
- ParametricRackHook_1767996688.parPAR · 364 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #198913
- Category
- Thể Thao & Ngoài Trời
- Published
- License
- Creative Commons — Attribution
Description
ENGLISH VERSION BELOW
🇩🇪 Deutsch
Ich habe diesen Halter entworfen, um lästige Kleinteile, wie Klammern oder Griffvarianten ordentlich und griffbereit direkt am Power Rack aufzubewahren.
Der Halter wird einfach auf das Vierkantprofil gesteckt und hält von selbst sicher, ohne zu wackeln oder im Weg zu sein.
Das Design ist kompakt, stabil und effizient– perfekt fürs Homegym, um lästiges Suchen zu vermeiden.
🛠 Anpassbar
Zusätzlich zur STL und STEP Datei habe ich eine parametrisierte Datei (.par) erstellt.
Damit kannst du das Modell sehr einfach an dein Rack anpassen.:
Einfach die Variablentabelle öffnen und die offengelegten Variablen anpassen.
Das Modell wurde in SolidEdge erstellt.
📦 Weitere Varianten
Wenn Interesse besteht, kann ich weitere Varianten hochladen.
👉 Einfach Bescheid sagen!
🖨 Druckhinweise
-
Material: Sunlu PLA+
-
Infill: 15 %
-
Wandlinien: 3
-
Schichtdicke: 0.3 mm
-
Keine Stützstrukturen nötig
🇬🇧 English
I designed this holder to keep annoying small items—such as clamps or different handle attachments—neatly organized and within easy reach directly on the power rack.
The holder simply slides onto the square tubing and stays securely in place on its own, without wobbling or getting in the way.
The design is compact, sturdy, and efficient—perfect for a home gym to avoid unnecessary searching.
🛠 Customizable
In addition to the STL and STEP files, I’ve created a parameterized file (.par).
This allows you to easily adapt the model to your rack:
Simply open the variable table and adjust the exposed parameters.
The model was created in Solid Edge.
📦 Additional Variants
If there’s interest, I can upload additional variants.
👉 Just let me know!
🖨 Printing Notes
-
Material: Sunlu PLA+
-
Infill: 15 %
-
Wall lines: 3
-
Layer height: 0.3 mm
-
No supports required
Print spec
- Formats
- parstlstp
- Model files
- 4
- Total size
- 4.4 MB
- Largest file
- 2.4 MB












