BOT Bánh xe (3lb)

it's a two part mould for a squishy wheel, you will need 2 component silicone and a pressure pot to get good results, fix your wheel (bests printed in TPU) with a m3 bolt to the bottom half, secure the sidewall with some tape to the bottom part. Mix your silicone well, (de-air) and fill the mold slowly (about 20g should be sufficient), in the best case scenario put it in your pressure pot or keep tapping the mold to the table for some time;)

To get the finished wheel out of the mould you will need to break it a little bit and definitely can not reuse the bottom part.

To get a pair of wheels you can mirror the bottom and wall part to get a left and right wheel, performance wise there won't be a difference but…;)