Skip to main content
F3D
Giá đỡ cột 32mm cho Ăng ten LoRa sợi thủy tinh… 1

2 images

DIY

Giá đỡ cột 32mm cho Ăng ten LoRa sợi thủy tinh (Meshtastic/MeshCore)

By wmnl

Downloads
3
Views
76

Files 2 198 KB

  • 32mm_pole_fiber_antenna_holder_1767929491.stlSTL · 126.5 KB
  • 32mm_pole_fiber_antenna_holder_1767929492.f3dF3D · 71.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#198391
Category
DIY
Published

Description

Elevate your LoRa gateway or Meshtastic node with this custom-designed pole mount. Specifically engineered for fiberglass omnidirectional antennas (like those used with RakWireless, Helium, or MeshCore kits), this mount provides a secure transition between a standard 32mm mast and your antenna base.

The mount features an internal centering ring that ensures your antenna stays perfectly vertical and won't rattle or lean during high winds.

Weatherproofing

To ensure a long-lasting outdoor deployment, the top of the mount is designed with a small clearance to allow for a bead of silicone sealant. Applying silicone at the junction where the antenna enters the mount prevents water from trickling down into the pole or onto your RF connectors.

Features

  • Precision Fit: Designed for a snug fit on 32mm poles.

  • Stability: Internal ring prevents "antenna sway."

  • RF Friendly: No metal hardware near the radiating element to interfere with your SWR.

  • Internal Housing: The 32mm pole diameter is wide enough to fit most small LoRa development boards. You only need to run a single USB-C or power cable up the pole.

To ensure this survives the elements, I recommend the following:

  • Material: PETG (Avoid PLA as it will warp in the sun).

  • Perimeters: 3–4 for structural strength.

  • Infill: 25% or higher

  • Supports: use tree supports

Assembly Instructions

  1. Connect a 5cm pigtail to your radio.

  2. Pass the pigtail through the mount and connect it to the antenna base.

  3. Slide the antenna into the mount until it seats against the internal ring.

  4. Seal it: Apply a bead of UV-resistant silicone kit around the top entry point where the antenna meets the plastic.

  5. Slide your radio into the 32mm pole, followed by the mount.

Read more Show less

Print spec

Formats
f3dstl
Model files
2
Total size
198 KB
Largest file
126.5 KB

0 comments

See all