Caddy đĩa Milwaukee M12 3" Compact Cut Off Tool (2522) tối ưu

This variant supports the stock hex key that comes with the cutoff tool, and other minor improvements.

Changes from the original:

• Hex key retention slot to hold stock M12 hex key that comes with the cutoff tool

• Arbor retention moved to box bottom

• Reduces overall dimensions for a smaller profile

• Tighter fit on discs

• Larger disc pickup finger holes

• Bottom disc raised to make for easier pickup

Like the original model by @SwirlStreet, I included the negative space punch-outs for use in other projects.

I checked some other Milwaukee tools, and the stock hex key's that come with their tools aren't all the  same size, so double check the specs if you use the retention punch-out it in other projects.

Requires 3 M3 x 30mm screws of any flavor.  I like these

https://amzn.to/4fvsXz9

Seal is not necessary and likely not waterproof but included for posterity, I printed the seal in TPU.

Everything else was in petg but likely works fine with most filaments. 

Room for improvements

• The parametric box this was built on has a minimum height for the lid. Using the lid only for hex key storage is not a great use of the space. Making the lid and base the same height would allow for disc storage on both sides, but a disc retention method would be needed. Maybe make them the same height as the Packout bit holders?

• Packout compatibility would be nice.

• The hex key retention is "fussy". It's either a bit tight or a bit loose based on how fast i run the printer. A better solve would be to put it in the bottom half of the box so you're not fighting gravity.

• The arbor nut hole could be mirrored on the opposite side of the base, but this isn't helpful unless you carry spare arbor nuts, which is uncommon.