Nồi pot cho hoa, thực vật, rau

Why?

I designed this system of pod to isolate a bit my plants from the floor of our balcony (which can be too warm).

At the same time I integrated water reserve in the middle sections, which you can fill by the top. when the first reservoir is full, water goes down a level.

Side pod are connected to it by a hole and use of material.

The idea was to irrigate by capillarity, but I doubt it will work that way. What is more probable is that plants roots will use the material as a support/guide to the reservoir.

The middle section was not printed at the same dimension, but I put here to allow people try it. It printed well bigger so no obvious reason for a fail.

Print:

Material: PETG

0.2mm layers

Nozzle: 0.4mm

No support needed for me.

Not compatible with vase mode.

A bit of time. For example on my Prusa Mini, individual pods takes +/- 7h. Central sections between 11 and 15h.