Bracket gắn K1 Max cho Low Rider MMU (mounting bracket)

This is a mounting bracket meant to fit on the back of a K1 Max. There are two versions: a plain mount that only requires four M4 Heatset Inserts, and a version with mounting locations for an on/off switch, USB panel mount, and power plug. This mount is meant to be used with the M4 Screw version of the Low Rider MMU side walls.

BOM:

• 4x M4 Heat-set Inserts

• 4x M3 x 14mm Socket Head Screws

• 1x USB-C Panel Mount

• 1x 5.5x2.1mm DC Power Socket

• 1x ON/OFF SPST Toggle Switch

Print with at least 5 walls and 35% Concentric infill. Remove the 4 screws on the bottom left of the rear printer panel and affix the mount with the longer M3x14mm screws. 16mm screws might work fine as well.