Giá đỡ chống lật cho kệ shelving rack

Safety bracket for reducing the risk of a shelving rack from tipping. The height on the shelves are adjustable by lifting the pieces so, the bracket ensures that this cannot happen on the part than it used to secure to the wall.

Use a stud finder to find a stud. Push the bracket down on the shelf edge, with the countersunk hole facing the wall (see photo). Use a 1.5-in or longer screw to attach the bracket to the stud (black screw in the photo). Optional, but recommended, you can also add a panhead wood screw to hold the other side to the shelf base.

Print on its side without supports. 3 perimeters (or 2 with a thick/0.8mm inner perimeter) recommended.

Disclaimer: This is provided merely for knowledge dissemination and without any guarantee. If you decide to print or use this part, you assume all risks and responsibility for any damages or injuries, should they occur during installation of the part or due to failure of the part.