Skip to main content
F3D
Hộp công tắc điều khiển nguồn PC… 1

3 images

DIY

Hộp công tắc điều khiển nguồn PC (PC power control switch box)

By guidosenff_296142

Downloads
34
Likes
14
Views
339

Files 2 792.9 KB

  • power_control_switchbox_-_cap_1767655194.stlSTL · 77.6 KB
  • power_control_switchbox_-_case_1767655195.stlSTL · 715.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I'm too lazy to press all the individual power switches all the time, so my PC desk has power switches for the following sections:
- MAIN
- PC
- DISPLAY
- OUTLETS

MAIN is a switch, which can be used to immediately switch everything on and off. PC is used for power outlets to which the PC and  docking station are connected and is mostly used to power cycle my docking station, which sometimes has issues and needs to be reset. My 3 LCD screens are connected to outlets behind the DISPLAY switch. And outlets are used to power off two active powered speaker.

I used a standard European phase, neutral and earth wire for input power and a 5 wire, phase,  neutral, earth and two switched wires, to power the individual power outlets.

Switch square size 29 x 21.20 mm

Rear cable holes:
- 12mm diameter (I used a Kalitec H07RN-F 5 x 1.5 mm² Rubber Cable)
- 8mm diameter

Bolt head head diameter 7.20mm, height 4mm and distance from bolt head to end of screw is 8.25mm, maximum thread length 40.875mm

Square nut should fit within 7.2x7.2mm. I hot glued them in place.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
792.9 KB
Largest file
715.3 KB

0 comments

See all