
Ngàm gắn AirTag top-mount cho DJI Neo 2
Remix of Kẹp giữ AirTag (AirTag holder) gọn nhẹ By VitaG_497425
- Downloads
- 3
- Likes
- 1
- Views
- 106
- Remixes
- 0
- Comments
- 0
Files 6 4.4 MB
- DJI_Neo_2_top_mounted_AirTag_-_hinge_gap_020_1767641235.3mf3MF · 531.5 KB
- DJI_Neo_2_top_mounted_AirTag_-_hinge_gap_025_1767641236.3mf3MF · 531.6 KB
- DJI_Neo_2_top_mounted_AirTag_-_hinge_gap_030_1767641237.3mf3MF · 531.8 KB
- DJI_Neo_2_top_mounted_AirTag_-_hinge_gap_035_1767641238.3mf3MF · 532.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #192391
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
Worried about losing your DJI Neo 2 drone? Add an AirTag!
This model allows you to clip an Apple AirTag on top of your DJI Neo 2 drone. It sits (nearly) in the center of mass of your drone, so it does not interfere with balance.
It sits on top of the battery, leaving the power button and LEDs accessible. When changing batteries, you need to unclip / clip the AirTag by gently compressing the arms on the clip - a matter of a few seconds.
The model prints without supports; it uses print-in-place hinges that should "unstick" fairly easily after printing by holding close to the hinges and gently pulling / rotating until they move freely.
Several variants are included, each with a different gap parameter: 0.20mm, 0.25mm, 0.30mm, 0.35mm and 0.40mm.
Printed on Core ONE L using Prusament PLA, 0.20mm layer height, no supports.
For me, the 0.20 and 0.25mm gap variants worked best; the 0.30mm and up were a bit loose - but YMMV.
Print spec
- Formats
- 3mf
- Model files
- 6
- Total size
- 4.4 MB
- Largest file
- 1.8 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -

-

-

-

-

-

-


