
Giá đỡ turntable cho Anycubic Wash and Cure 2.0
- Downloads
- 0
- Likes
- 0
- Views
- 58
- Remixes
- 0
- Comments
- 0
Files 1 2 MB
- Anycubic_Wash_and_cure_2.0_turntable_holder_1767643957.stlSTL · 2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #192370
- Category
- Máy In 3D
- Published
Description
A part that slides around the LED bar of the Wash and cure 2.0 and will provide a place to store the turntable.
- Important notes :
- My wash and cure is not stock, so this model will not fit a stock station.
I bought it second hand. On mine, like on many others of the same model, the break beam sensor (IR sensor bolted at the back of the LED tower) was not working properly.
To make it short, the station has a safety that prevents curing from happening unless the lid is on, for obvious reasons.
It does that by waiting for an IR break beam sensor bolted at the back of the LED tower to detect the lid thanks to a reflective sticker meant to bounce back the light at the sensor itself, making the machine know that the lid is on.
But on so many of those machines, the system backfired and made those stations unusable.
Somehow the sensor was getting messed up and would not detect the lid anymore, unless you would pull the lid closer to it. This was a very cumbersome solution to a stupid problem and I have seen it reported all over the internet.
Those same sensors were installed on the Photon Mono printers, but on those you have an option in the menu that allows you to deactivate the sensor, ending the problem. Wash and cure stations not being appliances you can flash a new firmware onto, updating the machine was never an option for stations.
I found a way to permanently fix this very annoying problem on mine.
I opened the bottom of the station, unbolted and unplugged the sensor, taped a square of paper to a wall inside the base, glued the sensor using double sided tape, facing that piece of paper, after having measured the distance it needed to be in relation to the paper, to be constantly detecting the wall. I then plugged the sensor back and closed the station.
This fix has been working for a very long time here.
More recently I got into Arduinos and sensors and got to use a bunch of break beams myself and I now know that the sensor could have been removed completely and the V and S pins could have been connected with a jumper wire, with a resistor in the middle. I have decided to keep the sensor taped facing the wall for now though.
My point is that this turntable holder will not fit on a machine that has the break beam sensor still mounted in place, as the part is hugging the tower tightly and the bolts that were originally holding the sensor are now used to bolt the part to the tower.
Though you could imagine cutting a space for the sensor, in slicer, if you really like where your break beam is located.
Additionally, my wash and cure did not come with a turntable, so I made one with THIS MODEL and a 150mm in diameter disk cut from a 5mm sheet of acrylic. I do not know the dimensions of the actual official turntable that came with those stations so my holder has not been designed to fit those. If it does, great, but that was not the objective.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 2 MB
- Largest file
- 2 MB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-

-

-

-

-

-


