Skip to main content
F3D
Khớp nối CordMate II (CordMate II coupler) 1

2 images

DIY

Khớp nối CordMate II (CordMate II coupler)

Remix of Coupler Cordmate II - Bắt vít (Screw-in Mount) By Pinnacle

By ScottK_139934

Downloads
1
Views
42

Files 2 57.3 KB

  • cordmate_ii_coupling_1767469757.stlSTL · 25.3 KB
  • cordmate_ii_coupling_1767469757.3mf3MF · 32 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#190701
Category
DIY
Published

Description

I needed an additional coupler for my wall-mounted Cordmate installation, and I didn't feel like driving to Home Depot for a $2 part. I found this coupler with a screw-in mount which was close to what I needed. I didn't need the screw-in mount, though, so I used TinkerCAD to remove it.

This is my first remix, so it was also a learning exercise for me. It's not a perfectly clean modification as I couldn't get TinkerCAD to fully remove the part closest to the coupler. I don't think you would notice it without getting up close to the wall. I was able to modify the final product a bit so there's no remnant of the screw-in mount.

I used Bambu Matte Ivory White PLA, 0.24mm draft mode. 

Photos show the printed model with the original CordMate II coupler next to it.

Read more Show less

Print spec

Formats
3mfstl
Model files
2
Total size
57.3 KB
Largest file
32 KB

0 comments

See all