Skip to main content
F3D
Coupler Cordmate II - Bắt vít (Screw-in Mount) 1

2 images

DIY

Coupler Cordmate II - Bắt vít (Screw-in Mount)

By Pinnacle

Downloads
9
Likes
2
Views
76
Remixes
1

Files 1 19.5 KB

  • CordmateII_Coupling_ScrewMounted_1767469765.3mf3MF · 19.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#190700
Category
DIY
Published

Description

These are couplers for the Legrand Cordmate II channels that can be screwed into the wall, ceiling, etc. for the channels on my garage ceiling for LED lighting. These channels were sagging due to poor adhesion with the sticky tape. These attached to the channels more firmly than the original, and the whole is just right to retain a #8 countersink wood screw.

Legrand Cordmate II Kit

BTW: I have Barrina 8 ft T8 LEDs (72W, 9000LM, 5000K) - Out of the box they're amazing! I daisy chained 2 sets of 5 of them (separate outlets for each set) and they are (were) extremely bright. I bought them 3 years ago, and I'm not starting to see LEDs die out on every tube and there are 2 tubes completely dead. They're not easily repairable, as the LEDs are on printed circuit board ribbons without visible solder to the LEDs… and the transformer assy is likely bad for the strands that are completely out. They're a good price out of the box, but consider you'll have to replace some or all every couple years. 

Printer Settings

  • Material Type: PLA - Not limited to
  • Layer Height: 0.2 mm
  • Top/Bottom Layers: 5
  • Wall Thickness: 1.0 mm
  • Supports: No
  • Infill: 15%, Grid (not required)
  • Ironing: Yes (not required)

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
19.5 KB
Largest file
19.5 KB

0 comments

See all