Skip to main content
F3D
Chống gãy cáp đầu in Flashforge AD5X… 1

1 image

Máy In 3D

Chống gãy cáp đầu in Flashforge AD5X (Print Head Cable Strain Relief)

By Nickatron_346994

Downloads
207
Likes
40
Views
777

Files 2 1.6 MB

  • AD5X_Print_Head_Cable_Strain_Relief_1767405533.stlSTL · 678.9 KB
  • AD5X_Print_Head_Cable_Strain_Relief_1767405533.blendBLEND · 941.7 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#190348
Category
Máy In 3D
Published

Description

This print is designed for TPU. Will likely only cause issues, and likely wont fit, if printed in a rigid filament. 

An expedient strain relief/ cable erector to keep the AD5X Print head cable from getting caught behind the print head with the IFS moved to the left side of the printer. 

Printed in 3 year old Duramic TPU which claims to be 95A, 0.2mm layer height, 0.4mm nozzle, on the AD5X. Printed standing up, but after printing I made a few tweaks so you should be able to lay it on the flat side and print it flat (untested). As long as it prints, it should be strong enough with TPUs layer adhesion. Supports are not advised with TPU, but do expect some sagging lines on the top of the strain relief holes.

Mounting it to the printer is easy enough, uses the two existing screws that are near the cable, remove those, pop the strain relief over the cable, slide it to the bottom, and screw the two screws back into place. The third, and left most screw hole is an empty hole on the 3d printer, but an m3x6 fits. (I suspect an m3x3 or larger will do the job, I cannot vouch for anything larger than an m3x6 not damaging something on the inside),

Blend file included.

Read more Show less

Print spec

Formats
blendstl
Model files
2
Total size
1.6 MB
Largest file
941.7 KB

0 comments

See all