Chậu Rapid Rooter - In Vase Mode Nhanh

I had a bunch of these rapid rooter plugs, but didn't have the tray to stand them in. Created this because I was only getting a few seeds started.

Just enable spiral vase mode and let the slicer do it's thing. Takes about 30 minutes to print at a 0.3mm layer height with a 0.6mm nozzle. The ones pictured were printed with a 0.8mm nozzle a bit faster.

You can add more layers to the bottom if you want more rigidity there.

Includes drainage holes and an optional stand if the surface you're putting these on won't allow the drainage holes to work, they're pretty stable without the stands though.

I was also able to fit 3 of these on the build plate at once and enabled "complete individual objects" if you need a few and don't want to hang around the printer to clear them off and start the next.