Nút bịt ống cho Rogue Vertical Plate Tree

Custom End Plugs for Rogue Vertical Plate Tree 2.0 (or similar 1.5" Schedule 40 pipe plate storage posts)

Bought a used Rogue Vertical Plate Tree from Facebook Marketplace and noticed it was missing the end plugs/caps on one side. Rather than leave the open tubes exposed (and potentially snag plates or look unfinished), I designed these tighter-fitting replacement plugs.

Print Recommendations:

• Print as-is (oriented flat side down)

• No supports required

• Material: PLA or PETG

• Infill: 20–40% is plenty

• Walls/perimeters: 3–4 for strength

Installation:

• Designed to fit slightly tighter than stock for a more secure hold

• Use hand pressure or a soft/rubber mallet to tap them fully into place

Enjoy!