Skip to main content
F3D
Dock sạc Nintendo Switch Lite hoạt động được (chỉ để sạc) 1

6 images

Dụng Cụ Tiện Ích

Dock sạc Nintendo Switch Lite hoạt động được (chỉ để sạc)

By MM_Printing

Downloads
291
Likes
59
Views
2,038

Files 2 166.5 KB

  • Switch_lite_dock_Front_1767355383.stlSTL · 137.9 KB
  • switch_lite_dock_2_v2_1767355383.stlSTL · 28.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Nintendo Switch lite dock for charging only. Your Switch Lite will NEVER be able to connect to the TV. 

Print Settings

  • layer height - .2 (Doesn't matter)
  • Nozzle Diameter - ≤.4 (Logo will not Work above .4)
  • Infill - If you can do a higher infill to make it heavier 

How to Assemble

First off you will need a USB-C charger like for your phone (NOTE: Official Nintendo chargers will not work for this.)

After you print out the 2 pieces you will need to put to charger cord through the slot than close the 2 pieces together. it should be a good fit but may be a bit loose so some Superglue should do the trick. The fit for the cord will probably be a bit loose (In case of varying sizes of the charger). Again some Superglue should hold it in Place.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
166.5 KB
Largest file
137.9 KB

0 comments

See all