Skip to main content
F3D
Bộ Chuyển Đổi Vỏ Đạn Vui Nhộn Cho Rival Fate 1

1 image

DIY

Bộ Chuyển Đổi Vỏ Đạn Vui Nhộn Cho Rival Fate

Remix of Wildstyle - Súng lục Shotgun Nạp Vỏ (Tự làm Nerf) By Sillybutts

By magmablaze19_1780053

Downloads
122
Likes
40
Views
985

Files 3 964.9 KB

  • FateBarrelWildstyleAdapter_1767176179.stlSTL · 279.7 KB
  • ModifiedShellCarriage_1767176181.stlSTL · 252.2 KB
  • ModifiedEjectorCarriage_1767176181.stlSTL · 433 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#185657
Category
DIY
Published
Tags

Description

Are you as broke as I am? Do you still need a way to take out special zombies at HvZ events? Then this remix is for you! Simply print out the two halves, screw them together with two 16mm M3 screws and two M3 nuts, improve your PT seal, add an o ring to the front, chuck it in your nearest rival Fate, and you're set!

If you want to use the ejector carriage, grab one of the ejector arms from the Wildstyle page linked under the original models section. I would suggest using a front lever, I dont think there is enough clearance for a back lever.

Bear in mind to shoot mega XL you will need to improve the stock seal of the fate. I used some plumbers tape and silicone grease to get close to a perfect seal. 

After seal improvements and a k25 spring swap, I'm hitting around 60-65 fps with MXL and a non rifled MXL silly shell. As I test more shells I will add more FPS readings.

Hope this helps you last a little longer against the horde! Happy hunting.

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
964.9 KB
Largest file
433 KB

0 comments

See all