
DIY
Gioăng Đĩa Luba
- Downloads
- 906
- Likes
- 53
- Views
- 6,163
- Remixes
- 0
- Comments
- 0
Files 2 1.7 MB
- Luba_Disc_Seal_1767173450.stlSTL · 878 KB
- Luba_Disc_Seal_Larger_Hole_1767173451.stlSTL · 878.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #185654
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
This mod is for those users who are tied of cleaning the grass that gets stuck behind the factory blade guard.
Why do I even need this? If you don't run this, then your rubber boot is no longer sealed and will allow water and debris directly inside of your Luba.
What are the benefits of this design over others out there?
- This Improves on the tolerance around the motor shaft which helps prevent debris getting tangles around the motor shaft by covering it up (As you can see in the comparison shot).
- Has extra protection built in for the rubber boot to stop debris cutting it open
- No supports required
Exposed blades too scary for you? Why not check out my Improved Luba Blade Guards https://www.printables.com/model/888061-improved-luba-blade-guards
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 1.7 MB
- Largest file
- 878.2 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-
New -
New -

-


