
Nắp thay thế cho tai nghe Logitech G Pro X
- Downloads
- 173
- Likes
- 10
- Views
- 763
- Remixes
- 0
- Comments
- 0
Files 3 3.8 MB
- outside_1767150269.3mf3MF · 93.7 KB
- inside_1767150270.3mf3MF · 441.2 KB
- clip_1767150270.FCStdFCSTD · 3.2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #184101
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Additional hardware requirements:
- Original cable retaining clip or you might try to print one from https://www.printables.com/model/895768-logitec-pro-x-wireless-headset-band-strap-cover , haven't tested the later
- M2x6 screws X4
- M2 hex nuts X4
Printing tips:
In the initial version (not uploaded) top surfaces of screw bosses separated. This was due to combination of:
- concentric circles
- thin top surface
- support on the inside
To mitigate this uploaded version (also in the picture):
- increased diameter and top surface
- apply box modifier in the problematic area reducing perimeter count to 1, that way it does more of bridging and there is more of criss cross stitching it together compared floating concentric circles that you would get with default slicing config
Problems/Potential improvements in future revisions:
The hooks might have been a bit too much and their making it slightly difficult to assemble, their size can probably be reduced.
When fully screwed together sliding adjustment was a bit too stiff. Had to slightly loosen the screws. Some tolerances could be improved although I am not sure where exactly. Maybe increase the height of screw boss by 0.1mm, so that it stops earlier without clamping everything else as tightly.
Print spec
- Formats
- 3mffcstd
- Model files
- 3
- Total size
- 3.8 MB
- Largest file
- 3.2 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -

-
New -
New -
New -

-
New -


