Skip to main content
F3D
Bộ Nâng Gầm Giảm Xóc MJX Hyper Go 10208 1

8 images

DIY

Bộ Nâng Gầm Giảm Xóc MJX Hyper Go 10208

By SvanB

Downloads
237
Likes
18
Views
1,872

Files 3 399.4 KB

  • MJX_10209_Shock_Lift_v11_11mm_1766862202.3mf3MF · 133.5 KB
  • MJX_10209_Shock_Lift_8mm_v3_1766862203.3mf3MF · 130.4 KB
  • MJX_10209_Shock_Lift_9mm_v3_1766862203.3mf3MF · 135.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#180369
Category
DIY
Published

Description

Buy here: https://www.etsy.com/uk/listing/1876691283/mjx-hyper-go-10208-shock-lift

This mod dramatically increases the droop and suspension range by moving the mounting point up 8-11mm. There is no drive shaft binding.

ride height:
front  = 58 mm (11mm version)
rear = 55 mm (11mm version)

Instructions:

  1. take note of the camber angle
  2. remove lower shock mounting bolts
  3. drill missing 3mm holes in stone shield 
  4. install shock lift part + stone shield with 2 M3x16 screw
  5. reinstall shock with M3x16 screw and locknut
  6. adjust camber angle

BOM:
M3 locknut x4
M3x16 bolt x8 (+ original shock screws)

Print Settings:
Print individually 
TPU 95A
5-8 parameters
60% infill

Read more Show less

Print spec

Formats
3mf
Model files
3
Total size
399.4 KB
Largest file
135.5 KB

0 comments

See all